Falls from height continue to be the biggest killer on construction sites. Do not attempt to use any fall protection system without full understanding of how to use all components and without adequate training in the specific application to which it is being applied.
All training must be conducted under careful and qualified supervision. Live hands-on training for all users is essential to help understand the capabilities and limitations of their personal protective equipment. Training also helps promote confidence and should be conducted as an initial introduction as well as periodically for review and additional practice.
INSPECT YOUR HARNESS BEFORE EACH USE
Inspect the harness to verify that it is in serviceable condition. Examine every inch of the harness straps for severe wear, cuts, burns, frayed edges, abrasion, or other damage. Examine stitching for any pulled, loose, or torn stitches. Do not use harness if inspection reveals an unsafe condition.
SELECTION CONSIDERATIONS FOR FALL PROTECTION EQUIPMENT
- The type of work being performed and the specific conditions of the work environment, including the presence of moisture, dirt, oil, grease, acids and electrical hazards, as well as the ambient temperature. For example, steel cable lanyards are particularly strong, heat resistant and durable; however, they are not suitable for use around high-voltage sources because they readily conduct electricity.
- Potential fall distance - This distance is greater than most people think, consider: the length of the lanyard, the length that the shock absorb-er will elongate during deceleration, the height of the worker, plus a safety factor.
- The compatibility of system components - A personal fall arrest system should be designed and tested as a complete system. Components produced by different manufacturers may not be interchangeable.
No comments:
Post a Comment